Lamp replacement
AMH12-3 lamp is used to illuminate the watch (W3W)
1. We take out the clock from the dashboard (see below).
2. Prying with a screwdriver, take out the cartridge with the burnt out lamp.
3. We remove the lamp from the cartridge and replace it.
Removing
1. We prepare the car for work (see "Vehicle preparation for maintenance and repair").
2. Disconnect the wire from the negative battery terminal (see "Battery - removal and installation").
3. Prying with screwdrivers through the side slots of the plastic ring, we take out the clock from the instrument panel. The ring is usually removed along with the watch.
4. After marking or remembering the location of the wires, disconnect them from the clock leads.
Installation
1. Install the plastic ring, aligning its protrusion with the groove in the hole in the instrument panel.
2. We connect the wires to the clock and install them in place.