Rear suspension of cars VAZ-21061 «Zhiguli»

Description of the rear suspension design
Rear suspension elements 1 – spacer sleeve; 2 – rubber bushing; 3 – lower spring insulating gasket; 4 – lower longitudinal bar; 5 – lower spring support cup; 6 – compression...

Checking the technical condition of the rear suspension
We check the tightening of the fasteners of all parts of the rear suspension. We tighten the loose connections. We visually check for damage to the springs, cracks and...

Replacing rear shock absorbers
It is more convenient to perform the work on a lift. To replace the shock absorber, we hang up the wheel and support the rear axle beam with a stand so that the shock absorber is...

Replacing rear suspension springs
We disconnect the shock absorber from the rear axle beam bracket and… …we tighten the spring with two special clamps (see Applications ). Instead of ties, you can use two or three...

Removal and replacing rear suspension parts
We place a hydraulic jack under the rear axle beam. We remove and replace them with new ones one by one (renovated) rear suspension parts. Using two 19 mm wrenches, unscrew the...

Replacing rear suspension rod bushings
If the rear suspension rod bushings are worn out, you can install new rods with factory-pressed bushings. However, you can also replace the bushings yourself using a special tool...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Rear suspension VAZ-2114 (2004-2013)
➠ Chassis: Rear suspension VAZ-2108 (1984-2003)
➠ Chassis: Rear suspension VAZ-2104 (1984-2012)
➠ Chassis: Rear suspension VAZ-2101 (1970-1983)
➠ Chassis: Rear suspension VAZ-2107 (1982-2012)

Share with friends: