Description of the design of the brake system 1 - brake disc; 2 - front brake caliper; 3 - vacuum amplifier; 4 - the main cylinder of the hydraulic drive of the brakes; 5 – the pipeline of a contour of a drive of forward...
Checking the condition of the hydraulic drive The condition of the hydraulic drive is checked visually. Leakage of brake fluid is not allowed. Metal pipelines should not have dents, cracks, they should be securely fastened...
Checking the vacuum brake booster The vacuum brake booster is a non-separable design, therefore, in case of failure, it is replaced as an assembly. The performance of the amplifier can be checked as follows: in a...
Checking the performance of the pressure regulator We check the pressure regulator with an assistant on the inspection ditch. We clean the regulator and the protective cover from dirt. We remove the protective cover from the...
Changing the brake fluid and bleeding the brake system Bleeding the brakes is necessary after replacing the brake fluid, as well as to remove air that has entered the hydraulic drive during the repair or replacement of individual...
Replacing the brake pads of the front wheels The pads must be replaced if the thickness of the friction linings has decreased to 1.5 mm as a result of wear. Raise the front of the car, install stands and remove the wheel....
Replacing the brake pads of the rear wheels We replace the rear brake pads when the friction linings are worn up to a thickness of 1.5 mm. Hang the back of the car and remove the wheel. Removing the brake drum (see Brake...
Front wheel brake caliper replacement Removing the front brake pads (see Replacing the brake pads of the front wheels ). Disconnect the brake hose from the caliper (see Replacing the front brake hoses ). Using a...
Replacing the brake cylinders of the front wheels Removing the front brake caliper from the car (see Front wheel brake caliper replacement ) and fix it in a vice. Remove the connecting tube of the working cylinders (see Repair of...
Repair of the brake cylinders of the front wheels Removing the front brake caliper from the car (see Front wheel brake caliper replacement ) and fix it in a vice. key «on 10» unscrew the fittings of the connecting tube of the...
Brake disc replacement The brake disc must be replaced if its thickness becomes less than 9 mm. Removing the front brake caliper (see Front wheel brake caliper replacement ), without disconnecting the...
Replacing the front brake hoses Hang and remove the front wheel. Pliers remove the bracket that fixes the brake hose in the body bracket. Holding the hose tip from turning with a wrench «at 17», key «on 10»...
Replacing the rear brake hose We carry out work on a viewing ditch or a lift. Pliers remove the bracket that fixes the hose in the body bracket. Holding the end of the hose with a wrench «at 17», key «on 10»...
Brake drum replacement Raise the rear of the car on stands and remove the wheel. key «at 12» unscrew the two guide pins,... ... we insert them into the technological holes and, wrapping, we shift the...
Replacing the brake cylinder of the rear wheel Removing the brake drum (see Brake drum replacement ). Prying off with a screwdriver, first remove one, then the other, lower parts of the brake pads from the support and slide...
Removal of the master brake cylinder and its repair With a rubber bulb, we select the brake fluid from the reservoir. key «on 10» we unscrew the fittings of the three brake pipes from the main brake cylinder, marking the order of...
Replacing the vacuum booster The vacuum booster is non-separable and cannot be repaired. In the cabin, pry off with a screwdriver and remove the spring retainer from the pin connecting the pusher to the brake...
Replacing and Adjusting the Pressure Regulator We are working on a viewing ditch. Two keys «on 10» disconnect the pressure regulator drive lever from the rod connected to the rear axle beam bracket. head «on 10» unscrew the...