Removing
1. We install the car on a viewing hole or overpass (see "Vehicle preparation for maintenance and repair").
2. With a rubber bulb, we select fluid from the clutch hydraulic reservoir.
3. Disconnect the rubber clamp securing the coolant expansion tank and move the tank to the side (see "Expansion tank - replacement").
4. Using a 13 mm open-end wrench, unscrew the pipeline fitting, remove it from the hole in the cylinder and set it aside.
5. Loosen the band clamp and remove the hose from the cylinder fitting.
6. Using a 13 mm socket wrench with an extension, unscrew the two nuts securing the cylinder and remove it from the studs.
Installation
1. Install all removed parts in reverse order.
2. Fill the liquid into the tank to the required level and pump the hydraulic drive system (see "Clutch release hydraulic - fluid change and bleeding").