Maintenance cars VAZ-2107 Zhiguli

All articles describing the main operations necessary for the periodic maintenance of the VAZ-2107 Zhiguli car and its modifications.

Description of the main systems of the car
Lubrication system combined: bearings of the crankshaft, camshaft and auxiliary drive shaft are lubricated under pressure, and the cylinders and valve timing mechanism are...

Filling volumes
Filling volumes, in liters Fuel tank (including reserve 4-6.5 l) - 39 Engine cooling system (including interior heating system) — 9,85 Engine lubrication system (including oil...
There is 1 comment

Basic data for adjustments and control
Clearances in the valve drive mechanism between the cams and levers on a cold engine, mm - 0.15 Gap between contacts of ignition distributor breaker, mm — 0.4±0.05 Axial clearance...

Car Care Schemes
The units, components and parts of the vehicle that are subject to periodic maintenance are indicated on the diagrams (fig. 21 and 22) numbers. Table 1 provides instructions for...

Engine lubrication
Oil pan Every 500 km check the oil level on a cold, non-running engine and top up if necessary. The oil level should be between the "Min" and "Max" marks on the oil level...

Valve timing mechanism
Clearances in the valve drive mechanism Every 10,000 km mileage, and on a new car after the first 2000-3000 km, check the gaps "A" (Fig. 25) between the cams and levers, which...

Tensioning the timing chain
Adjust the tension of timing chain 2 (Fig. 30) every 10,000 km. To do this, loosen locking nut 7 and turn the crankshaft 1–1.5 turns in the direction of its rotation. In this...

Power supply system
Air filter The vehicle is equipped with an air filter with a thermostat 4 (Fig. 31), which allows automatic maintenance of a constant air temperature at the inlet to the...

Exhaust gas toxicity reduction system
Fig. 34 shows a diagram of the exhaust gas toxicity reduction system. Any maintenance of this system should only be carried out at a service station. Fig. 34. Diagram of the...

Engine crankcase ventilation system
Every 20,000 km, clean and flush with gasoline the crankcase ventilation system hoses, the shut-off valve on the carburetor throttle shaft, and the flame arrester located in the...

Cooling system
Coolant Every 10,000 km check the mileage and, if necessary, restore the coolant level in the expansion tank. When the car leaves the factory, the cooling system is filled with a...

Cooling system thermostat
Every 20,000 km of mileage, and also in case of violation of the engine thermal regime (overheating under normal operating conditions or prolonged warm-up after start-up) check...

Ignition system
To ensure that the ignition system works properly, especially in winter, carefully monitor the cleanliness of the high-voltage wires; to ensure that there is no damage to the...

Transmission Maintenance
Clutch release hydraulic fluid reservoir Every 10,000 km check the fluid level in the tank (Fig. 41) and, if necessary, top it up to the lower edge of the filler neck. You should...

Hydraulic shock absorbers and anti-roll bar
Every 30,000 km mileage, check the performance of the shock absorbers. If their efficiency decreases, which is manifested in slow damping of vibrations (3-4 oscillations) the car...

Steering and wheels
Steering clearances Every 10,000 km mileage, and on a new car after the first 2000-3000 km, check the free play (play) of the steering wheel, which, with normal clearances in the...

Wheel replacement
To replace wheels: place the car on a level surface and lock the rear wheels with the parking brake; remove the spare tire, jack and toolbox from the trunk; loosen the mounting...

Checking and adjusting the front wheel alignment angles
Every 10,000 km mileage, and on a new car after the first 2000-3000 km, check the front wheel alignment angles. Also perform this operation after repairing or replacing front...

Maintenance of the brake system
Fig. 54 shows a diagram of the vehicle's braking system. Fig. 54. Brake system diagram: 1 - front brake circuit; 2 - master cylinder of the hydraulic brake system; 3 - front disc...

Car electrical system diagram
The basic diagram of the vehicle's electrical equipment is shown in Fig. 62. Table 4 indicates which ignition switch contacts and which circuits are energized when the...

Rechargeable battery
Every 2500 km mileage or every 4 months, check the electrolyte level in each battery cell (Fig. 63). The electrolyte level should always be between the "MIN" and "MAX" marks on...

Generator and starter
Generator Every 60,000 km mileage, and when operating the car on dirty and dusty roads, carefully clean the generator contact rings with sandpaper every 30,000 km, check the wear...

Headlight adjustment
Every 20,000 km mileage, and on a new car after the first 2000-3000 km, check and, if necessary, adjust the direction of the headlight beams. The car is equipped with headlights...

Replacing lamps
To replace the bulbs in the headlight, turn the casing 2 ( fig. 65 ) counterclockwise and remove it. To replace the headlight bulb, remove block 2 (Fig. 66), remove the ends of...

Fuses and fuses
The fuses are installed in the mounting block (Fig. 71). The mounting block is closed at the top with a transparent cover, on which symbols are applied indicating the purpose of...

Car body care
To maintain the attractive appearance of the car, constant preventive maintenance of the body coating is required. To avoid scratches, do not remove dust and dirt with a dry...

Car maintenance during long-term storage
The car is best stored in a dry, dark, well-ventilated room at a temperature of at least 5°C and a relative humidity of 50-70%. The battery and radio receiver can be left in the...

Design features of VAZ-21072 and VAZ-21074 cars
The VAZ-21072 car is equipped with a VAZ-2105 or VAZ-21011 engine, and the VAZ-21074 car is equipped with a VAZ-2106 engine. In this regard, the VAZ-21072 and VAZ-21074 cars have...

Configuration options for the VAZ-2107 car and its modifications
In a variant version, the VAZ-2107 car and its modifications can be equipped with a contactless ignition system (CISS) and a new design carburetor, which improves the car's...

List of tools and accessories supplied with the vehicle
item No Name Quantity 1 Tool box 1 2 Spanner 8x10 mm 1 3 Wrench 13x17mm 1 4 Tubular wrench 8x10 mm 1 5 Combination wrench for fastening wheels 1 6 Spark plug socket wrench 1 7...

Lamps used in the car
Name Type Headlight: - high and low beam lamp AKG12-60+55 — parking light lamp A12-4 — direction indicator lamp A12-21-3 Tail light: - fog lamp A12-21-3 — side light lamp A12-4 —...

Fuels and lubricants, operating fluids and automotive preparations

Information on the content of precious materials
Name Designation Weight, g gold silver platinum palladium Brake hydraulic reservoir (level alarm contacts) 21011-3505100 0,013027 0,076482 Three-lever switch 123.3709 0,1944...

Rolling bearings used in automobiles
Type bearing No Quantity Installation location Ball, radial, double row, with double-sided seal and groove on the outer ring 2105-1006124 1 Timing Belt Tensioner Mechanism Ball,...

Tightening torques for threaded connections
Detail Number of attachment points Thread Tightening torque Nm (kgf·m) Engine Oil pan mounting bolt 18 M6 5,2-8,4 (0,52-0,84) Breather cap fastening nut 1 M8 12-15 (1,2-1,5)...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ General information: Maintenance VAZ-2101 (1970-1983)
➠ General information: Maintenance VAZ-1111 (1988-1996)
➠ General information: Maintenance VAZ-2110 (1995-2007)
➠ General information: Maintenance VAZ-2105 (1979-2010)

Share with friends: