Removing
1. We install the car on a viewing hole or overpass (see "Vehicle preparation for maintenance and repair").
2. Drain the fluid from the hydraulic clutch release (see "Clutch release hydraulic - fluid change and bleeding").
3. Disconnect the rubber clamp securing the coolant expansion tank and move the tank to the side (see "Expansion tank - replacement").
4. With a 13 mm open-end wrench, unscrew the pipeline fitting, holding the tip of the brake hose from turning with a 17 mm open-end wrench. We pull the pipeline a little up and take it to the side.
5. Using pliers, remove the bracket for attaching the hose to the bracket and remove the hose tip from it.
6. Using a 17 mm wrench, unscrew the hose tip from the clutch slave cylinder.
Warning! There is an o-ring in the connection between the tip and the cylinder, do not lose it.
Installation
1. Install the hydraulic hose in reverse order.
2. Fill the liquid into the tank to the required level and pump the hydraulic drive (see "Clutch release hydraulic - fluid change and bleeding").