2. Disconnect the wire from the negative terminal of the battery (see "Battery - Removal and Installation").
3. Remove the headlight trim (see "Radiator grille and trim - removal and installation").
Replacing lamps
The exterior headlights of the car use halogen low/high beam lamps of the AKG 12-60+55 (H4) type, and the interior headlights use high beam lamps of the AKG 12-55 (H1) type.
4. To replace the lamp, use a Phillips screwdriver to loosen the three rim mounting screws.
5. Turn the rim clockwise to disengage its grooves from the screws. Remove the rim.
6. Remove the optical element and disconnect the wiring harness from the lamp socket.
Attention! When performing the following operation during installation, do not touch the glass bulb of the lamp with your hands to prevent it from becoming oily. Grease on the surface of the bulb will cause the lamp to overheat and fail prematurely.
7. After squeezing the spring clamps, remove the lamp from the socket.
8. Install the new lamp and optical element in the reverse order
Removal the headlight
9. To remove the outer headlight in the engine compartment, move the cambrics and disconnect the two ends of the headlight wires from the harness. To remove the inner headlight, disconnect the outer headlight wire and disconnect the headlight wire from the harness.
10. Using a Phillips screwdriver, unscrew the three screws that secure the headlight. Under the screw A the "ground" wire is secured.
11. Remove the headlight.
Installation
Installation of all removed parts is carried out in reverse order.