Contents: Removal ↓ Installation ↓
Removal
1. Prepare the vehicle for operations (see "Preparing a car for maintenance and repair").
2. In the car's interior, use a screwdriver to pry up the end of the cable and remove it from the gas pedal lever finger.
3. In the engine compartment, use thin pliers or a screwdriver to remove the spring clip from the throttle drive sector.
4. Turn the sector counterclockwise and remove the cable tip from the sector groove.
5. Move the protective cap from the end of the cable.
6. Using two 13 mm wrenches, loosen the nuts securing the cable sheath to the bracket.
7. Completely unscrew the front nut securing the cable sheath and remove the cable from the slot in the bracket.
8. Remove the rubber bushing from the hole in the engine compartment bulkhead and take out the cable.
Installation
1. Installation of the cable is performed in the reverse order.
2. We adjust the drive by changing the position of the threaded end of the cable sheath in the bracket, loosening and tightening the cable fastening nuts.
We achieve that when the gas pedal is released or pressed all the way, the throttle valve is, respectively, completely closed or completely open. When the valve is completely closed, the bracket platform A of the sector touches the adjusting screw B of the throttle valve body.
