We move the protective silicone cap from the tip of the cable sheath.
Using two 13 mm wrenches, loosen the nuts securing the throttle cable housing to the bracket.
After unscrewing the nut,...
...we take the cable out of the slot in the bracket.
After removing the spring retainer,…
...we remove the cable tip from the damper drive pulley.
In the passenger compartment, use a screwdriver to pry up the cable tip and remove it from the drive lever pin.
We remove the cable casing from the rubber bushing of the front shield.
The article is taken from the website VAZbook
Using a screwdriver, pry the rubber bushing out of the front shield.
We take out the throttle drive cable.
To remove the pedal...
...in the cabin, using a 13 mm socket, unscrew the two nuts securing the pedal bracket...
...and remove the pedal with the bracket.
We install the pedal and the throttle cable in the reverse order.
During assembly, we adjust the drive so that when the pedal is released and pressed, the valve is, respectively, completely closed and completely open.