We remove the electric fan to replace its parts or when removing the radiator.
Removing
1. Disconnect the pads of the impeller motor wires.
2. Disconnect the wire ends from the electric fan switch-on sensor (see "Sensor for turning on the electric fan - replacement").
3. socket wrench by 10 mm we turn off two bolts of fastening of a casing to a radiator on the left side and one - on the right.
4. Raise the electric fan, while pulling out the sheath of the sensor wires from the two clamps located on the casing.
5. Squeezing the petals of the clamps of the sheath of the sensor wires with pliers, we push the clamps out of the casing.
6. Remove the electric fan.
7. To replace the fan motor with a socket wrench by 13 mm unscrew the nut securing the impeller to the motor shaft, holding the impeller with your hand.
8. Remove the impeller from the shaft.
9. Squeezing the petals of the motor wire retainer with pliers, push the retainer out of the casing.
10. socket wrench by 10 mm unscrew the three nuts securing the motor to the casing.
11. Remove the motor.
Installation
Assembly and installation of the electric fan are carried out in the reverse order.