The gaps around the perimeter of the door should be the same.
To adjust the height, loosen the screws of both hinges and move the door vertically. Holding it in the required position, we wrap the screws with a Phillips screwdriver. We close the door and check its position in the opening. Repeat the adjustment if necessary.
The outer surface of the door must not be recessed or protrude relative to the adjacent door and wing. If necessary, push or «drown» the upper part of the door, loosen the three screws of the upper hinge and push it towards you, or we lower the upper part of the door. We wrap the screws with a screwdriver, close the door and check the coincidence of the outer surfaces of the doors and the wing.
In the same way we adjust the lower part of the door. After adjustment, finally tighten the screws with a Phillips impact screwdriver.
If necessary, the door can be removed without dismantling. To do this, perform the operations indicated on photo 1 and 4.