Features of the rear suspension device The rear suspension beam consists of two trailing arms 15 (pic. 98) and connector 14, which are welded together through amplifiers. In the rear part, brackets 16 with lugs for...
Removal and disassembly of the rear suspension Install the car on a lift or inspection ditch. Open the rear door and remove the reels with seat belts, side and rear trim in the luggage compartment. Loosen the nuts securing the...
Dismantling and assembly of shock absorbers The procedure for disassembling the shock absorber differs slightly from the sequence for disassembling the front suspension strut, namely: after removal of support 15 (pic. 100)...
Suspension arms — checking the technical condition Before checking, all parts are thoroughly washed. Rubber parts are protected from solvents during washing. Check the condition of the suspension arms, connector and suspension...
Suspension springs — checking the technical condition If cracks or deformations of the coils are detected by inspection, the spring is replaced with a new one. The draft of the spring is checked, for which the spring is pressed three...
Wheel hubs, bearings — checking the technical condition Check the condition of the threaded holes for the bolts of the wheel disks, the fit of the mud deflector ring. Turn the hub in both directions, while rolling should be smooth....
Assembly and installation of the rear suspension Assembly and installation of the rear suspension is carried out in the reverse order of disassembly and removal, taking into account the following: the rubber-metal hinge is...