The sensors are installed in the cylinder block on the left side.
We change the sensors on a cold engine.
Replacing the oil pressure gauge sensor
After removing the rubber cover, disconnect the wire from the sensor output.
key «at 19» unscrew the sensor.
We wrap the new sensor, making sure that its aluminum sealing gasket is in place and not damaged. We connect the wire, put on the cover and start the engine. In case of oil leakage, tighten the sensor with a wrench.
Replacing the low oil pressure sensor
Disconnect the wire tip from the sensor output. For clarity, we carry out the operation with the oil pressure indicator sensor removed.
key «at 21» or «at 22» (or candle wrench) unscrew the sensor.
We wrap the new sensor, making sure that its aluminum sealing gasket is in place and not damaged.
We connect the wire, start the engine. In case of oil leakage, tighten the sensor with a wrench.