The location of the lamps in the rear light sections: 1 - brake signal lamp A12-21-3 (P21W); 2 - reverse light lamp A12-21-3 (P21W); 3 - side light lamp A12-4-1 (T4W); 4 - fog light bulb A12-21-3 (P21W); 5 - direction indicator lamp A12-21-3 (P21W)
Lamp replacement
1. We prepare the car for operations (see "Vehicle preparation for maintenance and repair").
2. Disconnect the wire from the negative battery terminal (see "Battery - removal and installation").
3. Unscrew the plastic nuts securing the protective cover by hand and remove it.
4. Using pliers or fingers, alternately squeeze the petals of the two latches and remove the board.
5. We take out the board with the lamps from the rear light housing.
6. Drowning and turning counterclockwise, we take out the lamp.
7. We replace the faulty lamp with a new one.
8. Before installing the lamp, we clean the cartridge and the board from dirt and oxides. Often the malfunction is not related to the lamp, but to poor contact in the wire connector block. Having disconnected the block, we clean the contacts in the block and on the board.
Removing
1. Removing the protective cover (see above), press the latch and disconnect the wire block from the contacts on the lamp board.
2. Using an 8 mm socket wrench with a deep head, unscrew the four nuts securing the lamp. Tips are fixed under the nuts of two studs "mass" wires and "mass" fuel gauge sensor wires.
3. We take out the lantern from the hole in the body.
4. To replace the diffuser, remove it from the lamp body.
Installation
Assembly and installation of the lamp is carried out in reverse order.