Gap between contacts of ignition distributor breaker, mm — 0.4±0.05
Axial clearance in front wheel hub bearings, mm — 0.02 0.08
Maximum permissible axial clearance in the front wheel hub bearings during operation, mm — 0.15
Generator drive belt deflection under a force of 100 N (10 kgf), mm — 10—15
The gap between the spark plug electrodes, mm — 0.5–0.6
Free travel of the clutch pedal, mm — 25—35
Free travel of the brake pedal with the engine not running, mm — 3-5
Free play of the steering wheel in the position corresponding to movement in a straight line, no more than, degrees — 5
The same, when measuring along the wheel rim, mm - 18-20
Front wheel alignment of a run-in vehicle under load* when measured between rims, mm — 2–4
Front wheel camber of a run-in vehicle under load* when measured between the rim and the vertical, mm — 1–5
The same, deg — 0°30'±20'
Longitudinal tilt of the wheel rotation axis of a tested vehicle under load*, deg — 4°±30'
Transverse tilt of the wheel rotation axis of the tested vehicle, deg — 6°04'
Minimum permissible thickness of brake pads; mm:
- front brakes - 1.5
- rear brakes - 2.0
Temperature of the liquid in the cooling system of a warmed-up engine at an air temperature of 20-3°C, full load and movement at a speed of 90 km/h, no more than,°C — 95
The coolant level in the expansion tank on a cold engine is 3-4 cm above the "MIN" mark
The brake fluid level in the brake and clutch hydraulic drive reservoirs is up to the lower edge of the filler necks
Initial ignition advance angle before TDC, degrees — 3-5
Tire pressure 175/70SR13, MPa (kgf/cm²):
- front wheels - 0.17 (1.7)
- rear wheels - 0.20 (2.0)
Tire pressure 165/80R13 (165SR13), MPa (kgf/cm²):
- front wheels - 0.16 (1.6)
- rear wheels - 0.19 (1.9)
Maximum slope on dry hard ground on which a fully loaded vehicle is held for an unlimited time by the parking brake when the lever is moved by 4-5 teeth of the sector, % — 30
Density of coolant TOSOL A-40M at 20°C, g/cm³ — 1.078–1.085
* Load capacity 3200 N (320 kgf), which corresponds to a load of 700 N (70 kgf) on the two front and two rear seats plus 400 N (40 kgf) of cargo in the trunk.
Information on the content of precious materials in the vehicle is provided in appendix 4.
Content of non-ferrous metals and their alloys in the car:
- Aluminum alloys - 42.7 kg
- Copper alloys - 16.9 kg
- Lead alloys - 10.1 kg
- Zinc alloys - 5.6 kg