Dashboard:
- 1 - voltmeter;
- 2 - speedometer (vehicle speed indicator);
- 3 - odometer (trip odometer);
- 4 - tachometer.
Indicates the crankshaft speed. The yellow zone of the scale indicates the engine operation mode with a high crankshaft speed, the red zone indicates unacceptable modes. The maximum allowed engine speed is 6000 rpm;
5 - coolant temperature gauge.
The arrow in the green zone of the scale indicates the normal temperature of the coolant. Red zone - engine overheating. It is forbidden to operate the car at a coolant temperature above 118°C;
6 - econometer.
Helps you choose the most economical (in terms of fuel consumption) engine operation while the vehicle is in motion. In this case, the arrow of the device is in the green zone of the scale;
7 - block of control lamps:
- turning on the direction indicators (lights up with a green flashing light when you turn on the right or left turn);
- malfunctions of the engine management system (connects to a vehicle with an injection system. Lights up in orange when the ignition is on and goes out after starting the engine). In the event of a malfunction in the system, the indicator flashes or lights up permanently. Vehicle operation is not prohibited, as the system will switch to standby mode (with loss of power and increased fuel consumption). Eliminate the fault yourself or in a specialized workshop;
- battery charge. When the ignition is turned on, it lights up in red and goes out after the engine starts. If the lamp remains on after starting the engine, this indicates that the battery is not charged. The cause may be insufficient tension of the alternator drive belt, a malfunction of the alternator or the control lamp circuit. Continued driving with the light on may result in a complete discharge of the battery and engine shutdown, as well as a fire (if the fault is caused by an electrical short circuit);
- turn on side light (lights up green when the side lights are turned on);
- turning on high beam headlights (lights up blue when the headlights are on);
- insufficient oil pressure. When the ignition is turned on, it lights up in red and goes out after the engine starts. If the lamp continues to burn after starting the engine, this indicates low pressure in the engine lubrication system. To avoid engine failure, it should be turned off and the cause of the malfunction eliminated;
- applying the parking brake (lights up red when the ignition is on and the parking brake lever is raised).
Note: Additional indicator lamps are installed on the center console of the instrument panel:
- A - unfastened seat belts (lights up red when the ignition is turned on, if the driver's seat belt is not fastened; installed on car parts);
- B - turning on the rear window heating (lights up in orange when the rear window heating is switched on and the ignition is on);
- B - emergency state of the working brake system (lights up red when the fluid level in the reservoir of the hydraulic brake drive drops below the permissible level and the ignition is on).
8 - daily counter of the distance traveled;
9 - a control lamp of a reserve of fuel. Lights up yellow if there is less than 6.5-4 liters of fuel left in the fuel tank;
10 - fuel gauge;
Key switches:
1 - outdoor lighting switch. The three-position switch has three fixed positions. In the first - outdoor lighting is off; in the second - side light, license plate lamps and instrument illumination lamps are on; in the third - the dipped headlights are additionally turned on;
2 - rear window heating switch. Rear window heating is activated by pressing the key with the ignition on;
3 - fog light switch in the rear lights.
The fog light is turned on by pressing the button when the low beam headlights are on;
4 - heater fan mode switch. The switch provides two fan speeds - low and high.