Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Using a Phillips screwdriver, unscrew the two screws (the second screw is located on the opposite side of the overlay) rear mount pad...
... and two screws for the front mounting of the trim.
3. Using a screwdriver, detach the gear shift lever cover from the floor tunnel trim.
4. By rocking it left and right, remove the gear shift handle upwards together with the cover.
5. Raise the parking brake lever.
6. Using a screwdriver, remove the cover located under the lever.
7. Remove the floor tunnel cover.
Installation
1. Install the floor tunnel overlay in reverse order.
2. If it is necessary to replace the gear shift lever cover, remove it from the handle.
3. Put a new cover on the handle and secure it with insulating tape.
