Car front suspension VAZ-2114

All articles about the device and repair of the front suspension of cars VAZ-2114 (Lada Samara 114, hatchback) and their modifications.

Front suspension specifications
Table 10.2.1. Front wheel alignment angles under 320 kg load Front wheel alignment -0°30' - +0°30' Front wheel alignment, mm -1 - +1 Longitudinal tilt of the wheel pivot axis...

Description of the front suspension design
The front suspension is independent, with telescopic swivel struts, transverse levers, longitudinal arm braces and a torsion-type anti-roll bar. The suspension strut consists of a...

Front suspension — technical condition check
The technical condition of the front suspension must be checked in accordance with the periodic maintenance schedule (see " Periodic maintenance "). The technical condition of the...

Stretch mount bracket — removal and installation
To carry out the work you will need an inspection pit or overpass. 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Holding the stretch with...

Longitudinal suspension strut — removal and installation
Advice: When adjusting the longitudinal tilt angle of the steering axis at a service center, the longitudinal tensioner will be removed again, so it is better to replace the...

Ball joint of the rack — removal and installation
To complete the work you will need: ball joint pin extractor; car stand. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the...

Transverse suspension arm — removal and installation
To complete the work you will need: inspection pit or overpass; beard. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the...

Wishbone suspension — replacement of rubber-metal hinges
We replace rubber-metal hinges when the hinge in the lever rotates, elasticity is lost, the rubber element of the hinge is chipped or squeezed out of the seat. To complete the job...

Front suspension strut — removal and installation
To perform the work you will need a reliable support for the car. Removal Warning: Struts should be replaced in pairs, even if only one is faulty. 1. Prepare the car for work (see...

Front suspension strut — disassembly and assembly
To complete the work you will need: suspension spring clamps; suspension strut disassembly tool. Disassembly 1. Remove the rack from the car (see " Front suspension strut -...

Anti-roll bar — replacement of struts
To carry out the work you will need an inspection pit or overpass. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. With two keys by...

Anti-roll bar — removal, replacement of cushions and installation
To carry out the work you will need an inspection pit or overpass. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Unscrew the nut...

Front Wheel Alignment Check
To ensure proper rolling of the vehicle wheels, taking into account the operation of the suspension and steering, the front suspension elements must be installed in a certain...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Front suspension VAZ-2101 (1970-1983)
➠ Chassis: Front suspension VAZ-2107 (1982-2012)
➠ Chassis: Front suspension VAZ-21061 (1976-2006)
➠ Chassis: Front suspension VAZ-21214 (1994-2006)
➠ Chassis: Front suspension VAZ-2108 (1984-2003)

Share with friends: