Removal the front door lock
1. Prepare the car for work (see "Preparing a car for maintenance and repair").
2. Install the glass in the upper position.
3. Remove the door trim (see "Front door trim - removal and installation").
4. Using a Phillips screwdriver, unscrew the two screws securing the rear glass guide from the end of the door.
5. We take the guide down from the groove of the frame stand and move the guide to the side.
6. Using pliers, squeeze the petals of the rod holder and push it out of the hole in the inner door panel.
7. Using a Phillips screwdriver, unscrew the two screws securing the inner door handle.
8. Push the handle through the technological hole into the door.
9. Using a slotted screwdriver, disconnect the rod from the lock levers A larvae and traction B lock buttons.
10. Using a Phillips screwdriver, unscrew the three screws securing the lock.
11. Remove the lock with the rod and the inner handle from the technological hole in the inner door panel.
12. After removing the rubber retainer, disconnect the inner door handle drive rod from the lock lever.
Removal the front door outer handle
1. Prepare the car for work (see "Preparing a car for maintenance and repair").
2. Install the glass in the upper position.
3. Remove the door trim (see "Front door trim - removal and installation").
4. Disconnect the traction lock from the levers A and B (see above "Removing the front door lock").
5. To access the nuts securing the outer door lock handle, unscrew the three screws securing it (see above, "Removing the front door lock").
6. With a socket wrench by 8 mm using an extension, unscrew the two nuts securing the outer door lock handle.
7. Remove the handle, pulling it out together with the rod from the outer door panel. There is a rubber gasket between the handle and the door panel.
8. Remove the outer door handle seal.
9. Using a slotted screwdriver, disconnect the lock switch rod from the leash.
10. To replace the lock cylinder, use a punch to knock out the locking pin of the leash.
11. Remove the pin and remove the leash from the larva.
12. Remember the position of the spring and, using a slotted screwdriver, remove it.
13. Remove the lock cylinder from the hole in the handle.
Installation
1. Clean off dirt and lubricate the rubbing surfaces with aerosol or plastic lubricant.
2. Installation of all removed parts is performed in reverse order.