1. Prepare the vehicle for operations (see "Preparing a car for maintenance and repair").
2. Install the glass in the upper position.
3. Remove the door trim (see "Front door trim - removal and installation").
4. Using a Phillips screwdriver, unscrew the two screws securing the rear glass guide from the end of the door.
5. Move the guide to the side.
6. Using pliers, squeeze the petals of the rod holder and push it out of the hole in the inner door panel.
7. Using a Phillips screwdriver, unscrew the two screws securing the inner door handle.
8. Push the handle through the technological hole into the door.
9. Remove the rubber retainer and disconnect the outer handle drive rod A from the lock lever. Using a slotted screwdriver, disconnect the lock button rod B and the cylinder rod B from the lock lever.
10. Using a Phillips screwdriver, unscrew the three screws securing the lock.
11. Remove the lock with the rod and the inner handle from the technological hole in the inner door panel.
12. After removing the rubber retainer, disconnect the inner door handle drive rod from the lock lever.
Removal the door lock cylinder
1. Prepare the vehicle for operations (see "Preparing a car for maintenance and repair").
2. Remove the door trim (see "Front door trim - removal and installation").
3. Using a slotted screwdriver, pry up the plastic end of the rod and disconnect it from the lock cylinder.
4. Using pliers, remove the locking bracket from the slots in the cylinder.
5. Remove the cylinder with the seal from the hole in the outer door panel.
Removal the outer door lock handle
1. Prepare the vehicle for operations (see "Preparing a car for maintenance and repair").
2. Install the glass in the upper position.
3. Remove the door trim (see "Front door trim - removal and installation").
4. Disconnect the rod A of the outer handle from the door lock lever (see above "Removing the door lock").
5. With a socket wrench on 8 mm we unscrew the two nuts securing the outer door lock handle.
6. Remove the handle, pulling it out together with the rod from the hole in the outer door panel. There is a sealing gasket installed between the handle and the door panel.
Installation
1. Clean off dirt and lubricate the rubbing surfaces with aerosol or plastic lubricant.
2. Installation of all removed parts is performed in reverse order.