Removal the drop glass
1. Prepare the car for work (see "Preparing a car for maintenance and repair").
2. Lower the glass and remove the front door trim (see "Front door trim - removal and installation").
3. Mark the position of the cable relative to the pressure plate with a marker or a knot of thread.
4. Using a Phillips screwdriver, unscrew the two screws securing the cable pressure plate to the glass bracket.
5. Remove the plate and lower the glass until it stops.
6. To access the front guide of the drop-down glass, remove the protective film.
7. With a socket wrench by 8 mm unscrew the nut securing the front glass guide.
8. We move the guide down from the groove of the hinged glass frame pillar and remove it with the seal from the technological hole of the inner door panel.
9. Unscrew the two screws securing the rear guide of the lowering glass (see "Front door lock and outside handle - removal and installation").
10. Remove the window lift mechanism cable from the lower roller (see "Front door window lift mechanism - removal and installation").
11. Remove the glass with the bracket from the lower technological hole of the inner door panel.
Installation
1. Install the front door drop-down window in the reverse order, using the mark previously applied to the cable as a guide.
2. By moving the roller, we adjust the tension of the cable and check the smooth operation of the drive.
3. Lower the glass and, pressing the front guide towards it, tighten the nut that secures it.
4. Installation of the remaining removed parts is carried out in the reverse order.
Removal the pivot glass
1. Remove the drop-down glass (see above "Removing the drop-down glass").
The original can be viewed on the portal [www.VazBook.ru]
2. Remove the upper seal of the lowering glass from the door frame.
3. Using a Phillips screwdriver, unscrew the upper and lower screws securing the swivel glass frame.
4. Remove the frame with the swivel glass.
Installation
Installation of all removed parts is carried out in reverse order.