Rear door glass drive: 1 - power window handle; 2 - lining with a latch; 3 - socket; 4 - power window mechanism; 5 - top roller; 6 - glass bracket; 7 - clamping plate of the cable; 8 - screw; 9 - lower roller; 10 - tension roller; 11 - tension roller fastening nut
Removing
1. We prepare the car for operations (see "Vehicle preparation for maintenance and repair").
2. Remove the cable pressure plate (see "Rear door glass - removal and installation").
3. socket wrench by 10 mm we loosen the tightening nut of the tension roller, move it and remove the cable from the roller.
4. Raise the glass to the stop and fix it in this position with a suitable object, such as a wooden wedge.
5. Remove the cable from the other two rollers.
6. Socket or box wrench by 8 mm unscrew the three nuts securing the power window mechanism.
7. We take out the power window mechanism from the technological hole in the inner panel of the door.
Installation
1. Lubricate the cable with grease.
2. Installation of the power window mechanism is carried out in the reverse order, without allowing the cable to come off the power window mechanism drum.
3. By moving the roller, we tighten the cable and wrap the roller fastening bolt. We check the smooth operation of the drive.