Contents: Removal ↓ Installation ↓
To perform the work you will need an assistant, as well as a special 10 mm wrench for brake pipes, a transparent vinyl tube of a suitable diameter, a container for draining the brake fluid, fresh brake fluid (see "Operating fluids").
Removal
1. Place the vehicle on an inspection pit or overpass (see "Preparing a car for maintenance and repair").
2. Using a special 10 mm wrench for brake pipes, unscrew the pipe nipple, holding the hose tip with a 17 mm wrench.
(The original is posted on Internet resource: VazBook)
3. To reduce the loss of brake fluid, put a protective cap on the end of the tube (from the brake cylinder bleed nipple).
4. Using pliers, remove the clamp securing the hose.
5. Using a 15 mm wrench, unscrew the end of the hose from the tee and remove the hose.
Installation
1. Install the rear brake hose in reverse order.
2. Bleed the rear circuit of the brake mechanisms (see "Hydraulic brake drive - bleeding and replacing brake fluid").