Attention! We carry out work on a viewing ditch or a lift.
holding the key «at 17» flexible hose end, with a special key «on 10» unscrew the brake pipe fitting.
Remove the brake pipe.
To reduce the loss of brake fluid, we put on the end of the tube a protective cap of the wheel cylinder bleeder.
Pliers take out the bracket that fixes the hose tip in the bracket hole.
Remove the hose end from the hole in the bracket.
key «at 15» unscrew the hose tip from the tee mounted on the rear axle beam.
It is better to hold the tee with a key «at 17», otherwise - if the force is exceeded - the pin of its fastening may break off.
Remove the rear brake hose.
After installing the hose, it is necessary to bleed the hydraulic brake system (see Bleeding the brakes).