Note: To remove the glass, you must remove the window regulator.
1 – window lift guide mounting nuts
2 - nuts for fastening the window lift mechanism
1 – guide
2 – slider
3 – window lift mechanism
4 - location of window regulator marking
1. Remove the inner and outer lower glass seals. Then use a screwdriver to remove the protective film holders and remove the film from the door.
2. Remove the upper glass seal.
3. Install the window regulator handle and raise the glass so that...
4....the bolts securing the glass frame to the window lifter slider have become accessible. Unscrew both mounting bolts, holding the glass. Carefully lower the glass down.
5. Unscrew the three nuts securing the window lift mechanism.
6. Unscrew the two nuts of the middle window lift guide mount (see note).
7. Unscrew the nut of the lower guide mount.
8. Loosen the upper guide mounting nut while holding the window regulator.
The article is taken from an online resource [VazBook.ru]
9. Remove the window regulator from the door.
10. Turn the glass and pull it up (see note).
Note: The glass is removed in this position.
11. Check the tightness of the glass fit in the frame. If the frame does not sit tightly on the glass, replace the glass together with the frame.
Note: Raise the glass all the way up and remove the door trim.
12. When replacing the window regulator, pay attention to the part number: the bracket should be marked "2109" (the window regulator differs from the "2108" model). The last two digits of the part number (before the dash) denote: 10 - right, 11 - left.
13. Install the glass with the window regulator in the reverse order of removal.