Using a 22 mm wrench, unscrew the two self-locking nuts from the lower arm axle and remove the thrust washers.
It is convenient to press out rubber-metal hinges using a special device (see Applications).
We screw the hollow bolt onto the threaded end of the axle. We tighten the large nut of the device, pressing on the lever. In this case, the lever is pressed off the hinge, sitting on the lever axis.
We press out the second hinge in the same way.
Having inserted a new rubber-metal hinge into the lever, we center it in the hole, pressing the lever with a mounting blade.
We install the stop of the device on the inside of the lever and press the rubber-metal hinge into the lever.