In the engine compartment, through the hole in the mudguard, use a 17 mm wrench to unscrew the shock absorber rod mounting nut, holding the rod from turning with a 6 mm wrench.
From underneath the car, using a 13 mm wrench, unscrew the two nuts securing the shock absorber bracket and…
…we remove the shock absorber together with the bracket down through the hole in the lower arm.
Using two 17 mm wrenches, unscrew the nut and remove the bolt securing the shock absorber to the bracket.
The information is published on the website (VazBook.ru)
In case of wear, replace the upper rubber shock absorber mounting pads.
If the rubber-metal hinge is damaged, replace it. Before installation, completely pull out the shock absorber rod.
We install the shock absorber in the reverse order of removal.