Contents: Removal ↓ Installation ↓
Removal
1. Place the vehicle on an inspection pit or overpass (see "Preparing a car for maintenance and repair").
2. Drain the fluid from the clutch release hydraulic drive (see "Clutch release hydraulic drive - fluid replacement and bleeding").
3. Disconnect the rubber clamp securing the coolant expansion tank and move the tank to the side (see "Expansion tank - replacement").
4. With an open-end wrench by 13 mm unscrew the pipeline fitting, holding the tip of the brake hose from turning with an open-end wrench by 17 mm. We pull the pipeline up a little and move it to the side.
5. Using pliers, remove the clamp securing the hose to the bracket and remove the hose tip from it.
6. Key by 17 mm unscrew the hose tip from the clutch slave cylinder.
(The information is published on the website: «VAZBOOK.ru»)
Warning! There is a sealing ring installed at the connection between the tip and the cylinder, do not lose it.
Installation
1. Install the hydraulic drive hose in the reverse order.
2. Fill the tank with fluid to the required level and bleed the hydraulic drive (see "Clutch release hydraulic drive - fluid replacement and bleeding").