Removing
1. Remove the gearbox from the car (see "Gearbox - removal and installation").
2. Prying with a slotted screwdriver, remove the upper end of the spring from the protrusions of the clutch release bearing, and then the lower end of the spring.
3. Remove the clutch release bearing assembly from the guide sleeve.
4. Remove the spring.
5. Prying with a screwdriver, remove the rubber protective cover of the clutch release fork.
6. Prying with a screwdriver, remove the plastic sleeve of the clutch fork from the crankcase hole.
7. Having shifted upwards, we remove the lower end of the fork axis from the seat, and remove the clutch release fork.
8. If it is necessary to replace the guide sleeve of the clutch release bearing with a 10 mm socket wrench, unscrew the four bolts of its fastening.
9. Remove the sleeve from the input shaft of the gearbox.
Installation
We install all the removed parts on the car in the reverse order of removal, applying grease to the working surface of the clutch release bearing guide bush and both ends of the fork (SHRUS-4).