Removing
1. We prepare the car for work (see "Preparing the car for maintenance and repair").
2. With a Phillips impact screwdriver, loosen the two screws securing the outer part of the lock.
3. So that the inside of the lock does not fall inside the door, we unscrew the upper screw and instead screw in an M8 hairpin 7-10 cm long.
4. We unscrew the second screw and remove the outer part of the lock.
Installation
1. We install a new outer part of the lock and wrap the screw of its fastening, installing lock washers under the screws.
2. We turn out the hairpin and wrap the second screw securing the part of the lock.
3. Use a Phillips screwdriver to tighten the screws.
4. Lubricate the outer part of the lock with any grease.