Contents: Removal ↓ Installation ↓
Removal
1. Prepare the car for work (see "Preparing the car for maintenance and repair").
2. Open the hood and place it on the support.
3. Using a Phillips screwdriver, unscrew the four screws securing the inner lining of the radiator.
4. Remove the inner lining of the radiator.
5. Using a Phillips screwdriver, unscrew the two screws securing the radiator trim to the two brackets (on the right and left sides of the cladding).
Tip: The screws are only visible from below, but you can unscrew them "by touch" from above as well.
6. Remove the radiator grille.
7. If it is necessary to remove the headlight trims, remove the left wheel arch liner (see "Front fender liner - removal and installation").
8. Using a Phillips screwdriver, unscrew the screw that secures the headlight trim to the front wing. Use your fingers to press down the two fasteners (shown by arrow)...
...and remove the left headlight trim.
9. Remove the right headlight trim in a similar manner.
Installation
We install the facings in the reverse order.