You will need: a punch, a 13 mm socket head, and a ratchet.
1. Remove the front door trim (see "Removal and installation the front door trim").
2. Disconnect the two wire connectors of the door lock motor reducer.
3. Remove the retainer for the electric window and door lock motor wiring harnesses from the hole in the door panel.
4. Disconnect the wiring harness connector from the door power window.
5. Remove the rubber wire harness protection tube from the hole in the door panel…
[The article is taken from an online resource: vazbook.ru]
6. …and the wiring harness of the door lock motor reducer and the door electric window lifter.
7. Remove the pin from the eye of the front door opening limiter
8. Holding the door, unscrew the bolts securing the upper…
9. …and the lower door hinges to the body…
10. …and remove the door.
11. Install the door in the reverse order of removal, adjust the position of the door in the doorway if necessary; the gaps around the entire perimeter of the door relative to the opening must be the same.