Helpful advice. The hood is quite heavy, so we recommend removing and
set it up with a helper.
1. Disconnect the wire from the terminal «–» battery.
2. Open the hood and place it on the stop.
3. If you remove the hood not for replacement, mark the position of the hinges relative to the hood before removing.
4. Separate block of a wire of a lantern of illumination of a motor compartment.
5. Remove the rubber seal.
6. Remove the plastic clips of the hood soundproofing lining..
7.... and bend the trim to gain access to the wire of the engine compartment light.
8. Remove the engine compartment light wire through the hole in the hood reinforcement.
9. Disconnect the windshield washer hose from the tee..
10.... and pull the hose together with the sealing sleeve from the hole in the hood reinforcement.
11. Holding a cowl, turn out two bolts of fastening of a cowl to the left hinge.
12. Similarly turn out two bolts of fastening of a cowl to the right loop and remove a cowl.
13. Establish a cowl in an order, the return to removal, adjust its position so that backlashes between a cowl and both wings were identical.