1. For a hatchback type car, open the tailgate and remove the rear panel trim.
2. Disconnect the connector block with wires from the lamp board. Do this carefully, as the connector block sits tightly, and the bus is quite thin.
3. Press the plastic latch until the board disengages from the latch…
4. …and carefully remove the board from the flashlight housing.
5. On the back side of the board, lamps are installed in holders. The lamp power is indicated on the board near the holder.
6. Remove the burnt-out bulb. To do this, press lightly on the bulb, turn it and remove it from the holder.
[View the original on the internet resource: www.vazbook.ru]
7. Replace the lamp. Insert the board into the flashlight housing and secure with the latch.
8. Connect the connector with wires. The connector can only be connected in one position.
9. Install the removed parts in the reverse order of removal.