1. Loosen the clutch cable adjusting nuts.
2. Remove the lower end of the cable sheath from the bracket.
3. Disconnect the link from the clutch release fork lever.
4. Remove the retaining clip from the pedal pin from inside the passenger compartment.
5. Disconnect the cable end from the clutch pedal.
6. From the engine compartment side, remove the rubber cushion from the hole in the front shield…
[The original is available on the website: VazBook.ru]
7. …and pull the cable end through it towards the engine compartment.
8. Install the cable in the reverse order. The bushing between the rubber pads must fit into the bracket on the gearbox, otherwise the threads may be damaged. After installation, adjust the clutch drive (see Fig. "Adjusting the clutch release drive" in the subsection "Clutch").
