1 – clutch drive cable; 2 – rubber cushion; 3 – cable sheath; 4 – lower tip of the shell; 5 – adjusting nuts; 6 – leash
1. Loosen the clutch adjusting nuts.
2. Remove the lower end of the cable sheath from the bracket.
3. Disconnect the link from the clutch release fork lever.
4. Remove the retaining clip from the pedal pin from inside the passenger compartment.
[View the original on the internet resource: VazBook]
5. Disconnect the cable end from the pedal.
6. From the engine compartment side, remove the rubber cushion from the hole in the front shield and pull the cable end through it towards the engine compartment.
7. Install the cable in the reverse order. The bushing between the rubber pads must fit into the bracket on the gearbox, otherwise the threads may be damaged. After installation, adjust the clutch drive.