Engine lubrication system VAZ-21051 «Zhiguli»

Engine lubrication system — design description
Lubrication system device 1 – oil pump; 2 – oil pan; 3 – oil supply channel from the pump to the filter; 4 – horizontal channel in the cylinder block for supplying oil from the...

Oil and oil filter change
Removal the oil filter with tool A.30312 The oil must be changed on a hot engine. To completely drain the oil, you must wait at least 10 minutes after opening the drain hole. When...

Oil pump — removal, installation and repair
Main dimensions of the oil pump and its drive Removal and installation 1. Place the car on an inspection pit or lift, disconnect the wires from the battery and drain the oil from...

Oil pump drive shaft and gear
There should be no dents or scratches on the surfaces of the roller support journals and on the working surface of the eccentric. The teeth of the gears of the oil pump drive and...

Oil pump drive shaft bushings
Removal and installation oil pump drive shaft bushings 1 – mandrel A.60333/1/2 Check the inner diameter of the bushings, their press fit in the sockets, and the alignment of the...

Oil pump drive gear bushing
Pressing out the bushing of the oil pump drive gear and ignition distributor 1 – mandrel A. 60326/R Check the bushing press fit. The inner surface should be smooth and free of...

Flushing of engine crankcase ventilation parts
Engine Crankcase Ventilation Diagram A and B – operation of the carburetor spool valve at low crankshaft speed (A) and at high speed (B); 1 – oil separator drain pipe; 2 – oil...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Power unit: Lubrication system VAZ-21011 (1974-1983)
➠ Power unit: Lubrication system VAZ-2121 (1977-1994)
➠ Power unit: Lubrication system VAZ-1111 (1988-1996)

Share with friends: