Steering repair VAZ-2105

All articles about the device and repair of components and steering elements of the VAZ-2105 Zhiguli car.

The structure and operation of the steering system
The vehicles described are equipped with a single type of interchangeable steering system with a worm gear and a safety steering column. The steering shaft is composite and...

Possible steering malfunctions
Possible steering malfunctions, their causes and solutions are given in the table.

General inspection of the steering system on the vehicle
Before inspection, clean the steering gear parts and steering gear housing from contamination. Set the wheels to the straight ahead position and, turning the steering wheel in...

Checking the ball joints of the steering rods
First of all, check the movement of the rod ends along the axis of the fingers. To do this, using a lever and support, move the end parallel to the axis of the finger. The axial...

Checking and adjusting the clearance in the steering worm bearings
To check, set the front wheels to the straight-ahead position. Then, by turning the steering wheel in both directions, check whether the distance between the end of the crankcase...

Checking and adjusting the clearance in the engagement of the roller with the worm
Having made sure that there is no axial movement of the worm in the bearings, use puller A.47035 to press out the ball joint pins from the steering knuckle and disconnect the...

Removal and installation the steering gear
Removal To remove the steering gear, disconnect the wires from the battery and remove the signal switch by carefully bending the three latches from below through the window with a...

Disassembly and assembly of the steering gear housing
Disassembly Before disassembling, unscrew the plug 4 ( see fig. 184 ), drain the oil from the crankcase 7, then secure it to the bracket A.74076/R with the support A.74076/1....

Checking and repairing steering gear parts
Before assembling the steering gear, check: absence of visible signs of wear, jamming, dents or scratches on the working surfaces of the roller and worm. Replace worn and damaged...

Steering gear repair
Removal Remove the cotter pins and unscrew the nuts that secure the ball joints of the side rods to the steering arms; using puller A.47052 (Fig. 190), remove the ball pins from...

Repair of the pendulum lever
Removal and disassembly To remove the pendulum arm bracket, disconnect the pendulum arm from the ball joints of the middle and right side rods, having first unbolted the cotter...

Detailing of control mechanisms

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Steering VAZ-2110 (1995-2007)
➠ Chassis: Steering VAZ-2115 (1997-2012)
➠ Chassis: Steering VAZ-21011 (1974-1983)
➠ Chassis: Steering VAZ-2107 (1982-2012)
➠ Chassis: Steering VAZ-2121 (1977-1994)

Share with friends: