All articles devoted to the basic procedures necessary for the daily operation of the VAZ-2105 Zhiguli car.
Installing license plates To install the front license plate on the car, fasten the sign 5 (pic. 25) on two brackets 6 with screws 2 with washers 3 and nuts 4, and then fix the brackets on the front bumper...
Key position in the ignition switch Key in switch 1 (pic. 26) ignition can take the following positions: 0 — "Turned off" - everything is off, the anti-theft device is not included. The key is not removed. I —...
Starting a carburetor engine Starting a cold engine 1. Place the shift lever in neutral and pull out the carburetor choke control. 2. At very low ambient temperatures, turn on the headlights for a few seconds...
Diesel engine start Starting a cold engine 1. Insert the key into the ignition switch and turn it to the "1". At the same time, the heating of the glow plugs begins and the corresponding indicator in...
Starting an engine with a fuel injection system 1. Depress the clutch pedal and place the shift lever in neutral. 2. Insert the key into the ignition switch and turn on the starter. If the engine does not start on the first...
Gearbox control On fig. 28 shows the switching diagram of a four-stage (A) and five-speed (IN) gearboxes. To move in reverse, press the gear lever, sinking it all the way, and move it to the...
Car movement The movement of the car is recommended to start on a warm engine. If you do not have such an opportunity and you warm up the engine while driving, then at low ambient temperatures...
Braking and parking The design of the brakes provides effective braking. However, try to brake smoothly and moderately at all times, avoiding sudden braking. Do not turn off the ignition and do not...
Towing a car To tow the vehicle, attach the cable only to the front 1 (pic. 29) or back 2 eyes. Before towing, turn the key in the ignition switch to position "0" and turn on the hazard...
Operation of a new car During the run of the first 2000-5000 km: 1. Before each ride, check and correct the air pressure in the tires. 2. When the car is moving, do not exceed the speeds indicated in...
Ignition advance correction When operating a car, sometimes, depending on the quality of the fuel being refueled, it becomes necessary to correct the ignition timing. The ignition timing is corrected by an...
Precautions during operation of the vehicle The car is easy to drive, has high dynamic and high-speed qualities. However, do not rush to fully exploit these qualities until you have gained confidence in his driving and...
Interior ventilation and heating control The interior ventilation and heating are controlled according to the outside temperature as indicated below. Cabin ventilation Outside air can enter the vehicle interior: with the...
Interior lighting When the door is opened, the lamps 1 turn on automatically (pic. 33) interior lighting located in the central pillars of the car body. The interior lighting with the doors closed...