Description of the design of the driveline Cardan gear 1 – a bolt of fastening of an elastic coupling to a flange of a secondary shaft of a transmission; 2 – a flange of a secondary shaft of a transmission; 3 - rubber...
Removal and installation of cardan transmission 1. Place the vehicle on a lift or inspection ditch. 2. Chock the front wheels, release the parking brake, and place the shift lever in neutral. 3. Raise the rear axle so that the...
Checking the technical condition without disassembly After cleaning and washing the shafts, check the cardan joints for ease and smoothness of turning the forks and for the absence of significant axial and radial clearances. Check...
Dismantling the driveline Pressing the bearing out of the elastic support 1 - bar A.40005/2; 2 - paws A.40005/11; 3 - puller А.40005/4; 4 - paws; 5 - elastic support 1. Apply marks (paint or core), which...
Checking the technical condition of the driveline Eccentricity test 1. Install the front shaft in the centers and, turning, check the runout, which should not exceed: on the pipe, at a distance of 70 mm from the end welds - 0.55...
Balancing cardan shafts The scheme of dynamic balancing of the driveline If parts of the driveline were replaced during the repair, then its balancing is required. Dynamic balancing of cardan shafts in...