Description of the steering structure Steering 1 - lateral thrust; 2 - bipod; 3 - medium thrust; 4 - pendulum lever; 5 - adjusting clutch; 6 - lower ball joint of the front suspension; 7 - right rotary fist; 8 - upper...
General steering inspection 1. When there is a malfunction in the steering (knocks, increased free play of the steering wheel or, conversely, its tight rotation, etc.) inspect the steering parts. 2. Clean...
Checking the ball joints of the steering rods 1. First of all, check the movement of the rod ends along the axis of the fingers. To do this, using the lever and support, move the tip parallel to the axis of the finger. 2. The...
Removal and installation of the steering mechanism Steering parts 1 - steering gear housing; 2 - shaft seal; 3 - intermediate shaft; 4 - upper shaft; 5 - fixing plate of the front part of the bracket; 6 – an arm of fastening of a...
Disassembly and assembly of the steering gear housing Steering gear housing parts 1 - crankcase; 2 - bipod; 3 - lower crankcase cover; 4 - adjusting shims; 5 - the outer ring of the worm shaft bearing; 6 - separator with balls; 7 -...
Check and repair of the steering mechanism 1. Carefully inspect the working surfaces of the roller and worm for signs of wear, jamming, dents or scratches. Replace worn and damaged parts. 2. Check the gap between the...
Upper steering shaft — disassembly and assembly 1. Turn away a coupling bolt of a plug of the cardan hinge and disconnect an intermediate and top shaft of a steering. 2. In case of damage to the upper shaft or its bearings,...
Steering rods and ball joints Removing the ball pins of the steering trapezoid rods 1 - wrench; 2 - puller A.47052; 3 - ball joint; 4 - steering knuckle lever Cross section of the ball joint 1 - ball pin; 2 -...
Pendulum arm bracket Cross section of pendulum arm bracket 1 - pendulum lever; 2 – bracket body; 3 - washer; 4 - adjusting nut; 5 - cotter pin; 6 - top washer; 7 - sealant; 8 - bushing; 9 - the axis...