Front suspension of cars VAZ-2104

All articles about the arrangement and repair of the front suspension of VAZ-2104 Zhiguli (station wagon) and their modifications.

Description of the front suspension design
Front suspension parts: 1 - steering knuckle (2101-3001014/15); 2 - upper ball joint (2101-2904192-01); 3 - compression stroke buffer (2101-2904230); 4 - upper arm...

Front suspension — technical condition check
Periodically check the condition of the front suspension (see " Periodic maintenance "). Work related to checking or repairing suspension components is more conveniently performed...

Wheel alignment angles — adjustment
Wheel alignment angles are design parameters that determine the position of the wheels in straight-line motion mode and in turns. Deviation of wheel alignment angles from standard...

Front Wheel Hub Bearings — Adjustment
Increased clearances in the front wheel hub bearings lead to a reduction in their service life, vibrations during movement and accelerated tire wear. Excessively tightened...

Hub — replacement of seal, grease and bearings
We replace the hub bearing grease according to the maintenance regulations every 20,000 km. We replace the hub bearings in pairs if increased noise cannot be eliminated by...

Front Suspension Shock Absorber — Replacement
The shock absorber is replaced if it leaks fluid or loses its ability to dampen vibrations, the rod is deformed, and the rubber-metal hinges are destroyed. Shock absorbers should...

Front Suspension Spring — Replacement
According to the length under the standard load, springs are divided into two groups: A - "long" and B - "short". Group A springs are marked with yellow paint, group B - green....

Upper arm — removal and replacement of rubber-metal hinges
We remove the upper suspension arm in case of mechanical damage or to replace the rubber-metal hinges. Front suspension upper arm mounting parts: 1 - self-locking nut M14x1.5...

Rubber-metal hinges of lower arms — replacement on the car
We replace rubber-metal hinges when they are worn out or damaged. To perform the work, you will need a device for pressing out and pressing in rubber-metal hinges. Removal 1....

Lower arm — removal and installation
We remove the lower arm in case of mechanical damage or to replace the rubber-metal hinges. Front suspension lower arm mounting parts: 1 - self-locking nut M14x1.5 (12574811); 2 -...

Anti-roll bar cushions and rod — replacement
We remove the anti-roll bar when the rod is deformed or when replacing all the rubber cushions of its mounting brackets. We replace the rubber cushions of the clamps of the...

Ball joints — replacement
Upper ball joint parts: 1 - pressure plate (2101-2904078); 2 - ball joint cover (2101-2904070); 3 - upper ball pin (2101-2904192-01) Removal 1. Prepare the vehicle for operations...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Chassis: Front suspension VAZ-2101 (1970-1983)
➠ Chassis: Front suspension VAZ-2107 (1982-2012)
➠ Chassis: Front suspension VAZ-2114 (2004-2013)
➠ Chassis: Front suspension VAZ-2106 (1976-2006)
➠ Chassis: Front suspension VAZ-2121 (1977-1994)

Share with friends: