Removing the door trim (see Removing the door upholstery).
Disconnect the power window cable attachment to the front and rear glass holders (see Door glass replacement).
Raise the glass with our hands..
... and fix it from falling with a screw (or hairpin) with M5 thread, screwed into the hole of the front glass holder.
head «for 8» unscrew the three nuts securing the power window mechanism to the inner door panel.
We bring the window mechanism to the window in the door panel.
If the power window mechanism is not replaced, but removed when the door is completely disassembled,..
... then we tie the wire branches of the cable near the drum of the window regulator mechanism.
We lower the glass with our hands to the rubber buffer (see Door glass replacement).
We remove the cable from four rollers..
... and take out the window regulator mechanism with a cable.
head «on 10» unscrew the bolt securing the tension roller bracket..
... and take out the bracket with the roller.
When assembling, having installed the bracket of the tension roller, we do not tighten the bolt of its fastening.
Raising the glass, fix it.
We pass the shaft of the window regulator mechanism into the hole in the inner panel of the door (the new power window mechanism is sold with bundled cable strands).
We put the cable on the rollers according to the scheme.
With side cutters we bite the wire that fixes the branches of the cable.
We pass the studs of the window regulator mechanism into the holes and fasten the mechanism.
To tension the cable, slightly tighten the bolt of the tension roller bracket.
Tapping the head extension with a hammer «on 10», put on the bracket bolt,..
... we shift the roller down, pulling the cable. Finally tighten the bolt.
We bait the screws of the two clamping bars of the glass holder brackets and slightly tighten the screws of the front bracket bar.
We rotate the handle put on the window lifter mechanism shaft counterclockwise until the rotation of the window lifter mechanism drum stops. We raise the glass with our hands until it stops and, holding it in this position, turn the handle put on the shaft of the window regulator mechanism clockwise by half a turn.
Using a Phillips screwdriver, through the window in the upper part of the inner door panel, finally tighten the screws of the front bracket bracket of the glass holder.
We lower the glass to the level when it will be possible to tighten the screws of the lath of the rear bracket of the glass holder through the window of the inner door panel (see Front door glass replacement).
After checking the operation of the window regulator mechanism, we lubricate the cable and rollers with Litol-24 grease.