Rear protective film with mounting holders.
1 – window lift guide mounting nuts
2 – nuts for fastening the window lift mechanism
1 – location of window regulator marking
2 – slider
3 – guide
4 – window lift mechanism
1. Lower the glass all the way down and remove the rear door trim in the same way as removing the front door trim. The photo shows the location of the rear door trim mounting pins.
2. Remove the inner lower glass seal.
3. Remove the three holders (two on top and one on the bottom), by prying them with a screwdriver. Remove the rear protective film from the door (see note).
4. Loosen the two bolts securing the glass clip to the window lifter slider while holding the glass. Carefully lower the glass down.
5. Unscrew the two lower and one upper nuts securing the window regulator guide.
6. Unscrew the three nuts securing the window lift mechanism.
7. Remove the window regulator from the door.
8. Remove the outer lower glass seal.
9. Remove the top seal.
12. Install the glass with the window regulator in the reverse order of removal.
10. Turn the glass back and remove it from the door.
11. Check the tightness of the glass fit in the frame. If the frame does not fit tightly, replace the glass together with the frame.