Checking the level
1. Prepare the car for work (see "Preparing a car for maintenance and repair").
2. Remove the oil level indicator (dipstick) from the guide tube, wipe it with a clean rag and install it into the tube until it stops.
3. Remove the dipstick again and check the level of the oil film on it, which should be between the "MIN" and "MAX" marks.
Attention! Exceeding the oil level in the engine crankcase above the "MAX" mark may lead to its leakage through the seals, gaskets and crankcase ventilation system.
4. If the oil level is close to the "MIN" mark, add the oil recommended by the manufacturer (see "Applications").
Caution! The oil level gauge is marked with the engine code. Do not use a gauge with a different code.Replacement
To complete the work you will need a container for draining oil, with a capacity of at least 4 liters.
It is recommended to change the oil when the engine is warm.
1. Place the vehicle on an inspection pit or overpass (see "Preparing a car for maintenance and repair").
2. Remove the oil filler cap.
Note: According to the maintenance schedule, it is necessary to flush the engine lubrication system every 30,000 km. To do this, drain the old oil without unscrewing the oil filter. Fill with flushing oil up to the "MIN" mark on the dipstick, start the engine and let it idle for about 10 minutes (see flushing oil manufacturer's recommendations). Drain the flushing oil and replace the oil filter. Fill the engine with motor oil to the required level.
3. With a hex key by 12 mm we unscrew the drain plug of the oil pan.
4. Drain the oil into a prepared container.
5. Using a puller or by hand, unscrew the oil filter.
6. Clean the threads of the drain plug and screw the plug back in.
7. Pour fresh oil into the new filter and lubricate the rubber gasket with it.
8. Screw the filter onto the fitting and after the gasket touches the block mating ring, turn the filter an additional 3/4 turn.
9. Fill the engine with fresh oil (see "Applications").
10. After waiting 2-3 minutes, remove the dipstick and check the oil level.
11. Install the oil filler cap.
12. Start the engine for a few minutes, then stop it and check the oil level and the absence of leaks from under the filter gasket and drain plug.