Contents: Removal ↓ Installation ↓
We replace the cylinder head cover gasket if there are oil leaks.
Removal
1. Prepare the car for work (see "Preparing a car for maintenance and repair").
2. Remove the air filter (see "Air filter housing - removal and installation").
3. Disconnect the air damper drive cable from the carburetor (see "Carburetor cover - removal and disassembly") and the throttle actuator rod end (see "Carburetor - removal and installation").
4. Disconnect the longitudinal rod of the carburetor throttle drive from the lever.
5. Remove the carburetor fuel hose from the bracket.
6. Key by 10 mm we unscrew the eight nuts securing the cover and remove the special washers.
7. Release the wiring harness, brake booster and crankcase gas outlet hoses from the holder.
8. Remove the cylinder head cover from the studs.
9. Remove the cover gasket.
Installation
1. Installation of all removed parts is carried out in reverse order.
2. Tighten the cylinder head cover fastening nuts according to the diagram to a torque of 6-7 N·m (0.6-0.7 kgf·m).
