We disconnect the tension spring.
Using pliers, remove the cotter pin from the end of the pusher.
Using a 17 mm wrench, loosen the hose tip fastening in the cylinder plug.
[The original can be found on the website VazBook.ru]
Using a 13 mm socket head, unscrew the two bolts securing the cylinder to the clutch housing.
Holding the end of the hose with a 17 key and rotating the cylinder with your hands, disconnect it from the hose.
To reduce fluid loss, immediately screw a new cylinder onto the hose tip. Next, install the cylinder in the reverse order of removal and adjust the gap between the pusher and the fork.
After installing the new cylinder, bleed the clutch hydraulic system (see Replacing fluid and bleeding the clutch hydraulic drive).