Warning: To avoid damaging the ratchet mechanism, do not use ratchets to loosen and finally tighten bolts and nuts.
Since the car uses TORX bolts, as well as Allen bolts, the kit should include sets of corresponding heads and bits, as well as bits with a working profile for Phillips and slotted screwdrivers.
2. A wicket with a hinge and a long handle. It is necessary for loosening large diameter threaded connections when significant effort must be applied (for example, when loosening the front wheel hub bearing nut).
3. Set of combination wrenches (open-end and box-end wrenches) dimensions from 6 to 32 mm. It is desirable to have a full range of metric size keys available (through 1 mm).
Warning! Open-end wrenches are not intended to apply significant force to fasteners, as this will crush the edges of bolts and nuts. Tighten or loosen with such wrenches only when it is impossible to do so with socket or ring wrenches.
4. Set of open-end wrenches. It is useful to supplement the set of combination wrenches with open-end curved wrenches of the most common sizes: on 10, 12, 13, 15, 17, 19, 22 and 24 mm.
5. Set of Allen keys size from 2 to 12 mm.
(The article is taken from the website vazbook.ru)
6. Torque wrench. Designed for final tightening of threaded connections with a specified torque.
7. Set of Phillips and slotted screwdrivers, varying in size and length. It is very convenient if, when performing repairs, there is a large selection of screwdrivers with blades of different lengths and widths available.
8. Hammers. It is advisable to have several hammers with a steel striker weighing 200, 500, 1000 g, and in addition, with a plastic or rubber striker.
9. Nippers (side cutters), combination pliers, flat-nose pliers.
10. Awl
11. Soft metal punches (brass, copper, aluminum rods) for knocking out axles and shafts.
12. Set of steel punches and drifts for knocking out pins, cotter pins, etc.
13. Chisel. It is better to buy two or three chisels with different blade widths. It is also advisable to have a long chisel for working in hard-to-reach places.
14. Hacksaw for metal, set of needle files and rasps.
15. Mounting spatula. You should have a set of two or three blades of different lengths that can be used as levers.
16. Sliding pliers
17. Metal brushes.
18. Electric drill with a set of drills for metal (up to 13 mm).
19. Bench vice. The vice must be securely fastened to the workbench.