All articles about the installation and repair of electrical equipment of the engine (generator, starter, ignition, etc.) of VAZ-2110 (Lada 110) cars and their modifications.
Generator — device and description The vehicle is equipped with a three-phase alternating current generator with electromagnetic excitation, diode rectifier unit and built-in voltage regulator model 9402.3701 or...
Checking the generator without removing it from the car To complete the work on checking the generator, you will need: multimeter (in the voltmeter mode with a measurement limit of 1520 V); technical stethoscope. assistant. Check...
Checking and adjusting the alternator belt tension 1. We prepare the car for repair work. 2. Press the belt with a force of 98 N (10 kgf) exactly in the middle between the alternator pulley and the engine crankshaft pulley....
Alternator Belt Replacement Removing 1. We loosen the nut of the bolt of the lower mounting of the generator and the nut of the tension bar. 2. Loosen the alternator belt tension. 3. Having shifted the...
Removal, installation and repair of the generator To carry out repair work, an inspection pit or overpass will be required. Removing 1. We prepare the car for repair work. 2. Disconnect the wire terminal from the negative battery...
Dismantling, checking parts and assembling the generator To perform the work on disassembling the generator, you will need: multimeter; power supply with adjustable voltage up to 20 V or battery charger; three or two-jaw puller; mandrel...
Device and description of the starter The car has a starter type 57.3708 (or its modification), which is a DC motor with permanent magnet excitation and an integrated planetary gear. A traction relay is installed on...
Removal and installation of a starter Removing 1. We prepare the car for repair work. 2. Disconnect the wire terminal from the negative battery terminal. 3. Remove the air filter housing. 4. Disconnect the wire...
Check, dismantling and repair of a starter Note. Depending on the malfunction that has occurred, the sequence and scope of repair work can be changed. The most common starter failures are: 1. The winding burns out or the...
Description and technical characteristics of the battery The car is equipped with a starter maintenance-free storage battery with a capacity of 55 Ah. The battery consists of six series-connected batteries assembled in one housing. On...
Removing and installing the battery Warnings: Disconnect the battery only when necessary. Disconnecting the battery deletes fault codes and all settings generated by the engine management system from the computer's...
Battery maintenance Warning. When servicing the battery, you must follow the safety regulations. To get the job done you will need: a special tool for cleaning battery terminals and power wire...
Battery check Warning. When servicing the battery, you must follow the safety regulations. To get the job done you will need: hydrometer; voltmeter. Check sequence 1. Disconnect both wire...
Charging the battery To perform battery charging work (battery) you will need: Charger; hydrometer. Warning. Servicing the battery, you must follow the safety regulations. Charging sequence 1. Remove...