Headlights and lighting systems for cars VAZ-2112

All articles about the installation and repair of headlights and systems of external and internal lighting of VAZ-2112 (Lada 112, hatchback) and their modifications.

Outdoor lighting and light signaling
The vehicle uses two headlamp units, which have high-beam and low-beam lamp reflectors installed in a single housing. Headlamp units from different manufacturers may differ in the...

Headlight unit — light adjustment
To complete the work you will need an assistant, as well as: flat horizontal area (preferably near the wall of a house, fence or gate); 5m tape measure; sheet of cardboard (to...

High and low beam lamp — replacement
Warning! Do not touch the halogen bulb with your fingers. Work in clean cotton gloves without rubber coating. Grease marks from your fingers left on the bulb will shorten its...

Parking light bulb — replacement
Removal 1. Remove the high beam section cover (see above). 2. Without disconnecting the wires, remove the side light bulb socket from the reflector. 3. Remove the lamp from the...

Turn signal lamp — replacement
Note: On early production vehicles, the upper cross member of the front panel is straight and does not have additional shields. The turn signal lamp is accessible from the engine...

Headlight — removal and installation
Tip: To reduce the risk of damaging the paintwork of the car body, it is preferable to remove the bumper (see " Front bumper - removal and installation "). Note: The work is shown...

Front turn signal — removal and installation
Removal 1. Remove the headlight (see above, " Headlight - removal and installation "). 2. Using a slotted screwdriver, unscrew the two screws securing the front turn signal to the...

Side direction indicators — bulb removal and replacement
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Move the side turn signal forward together with the sealing gasket. 3. Pulling back...

Rear Exterior Light Bulbs — Replacement
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. In the luggage compartment, open the valve in the decorative trim, under which the...

Rear Interior Light Bulbs — Replacement
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Without disconnecting the wiring block, squeeze the spring clips and remove the...

Rear light (outer) — removal and installation
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Turn off the outside lighting. Note: When removing the left light, remove the...

Rear light (inner) — removal and installation
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Remove the inner trim of the luggage compartment door (see " Trunk door trim -...

Additional brake light — removal and installation
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Using a Phillips screwdriver, unscrew the three screws securing the additional brake...

License Plate Lights — Removal, Replacement of Bulbs and Installation
The license plate lights are installed in the recess of the rear bumper. Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Turn off...

Interior light — lamp replacement, removal and installation
Note: To replace a faulty lamp, simply remove the lampshade diffuser (see below p. 1-3), replace the lamp and install the diffuser in place (see "Installation"). Removal 1....

Individual illumination lamp — removal and installation, lamp replacement
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Turn the outer ring of the lamp housing clockwise. Pry the ring with a slotted...

Trunk light — removal and installation, lamp replacement
1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Turn off the outside lighting. 3. Using a slotted screwdriver, pry up the front edge of the...

Fog light — removal and installation, lamp replacement
Removal 1. Prepare the car for work (see " Preparing the car for maintenance and repair "). 2. Turn off the outside lighting. 3. Using a Phillips screwdriver, unscrew the two...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More articles from other manuals on VAZ cars:
➠ Electrical equipment: Lighting and signaling VAZ-21011 (1974-1983)
➠ Electrical equipment: Lighting and signaling VAZ-21061 (1976-2006)
➠ Electrical equipment: Headlights and lighting VAZ-21214 (1994-2006)
➠ Electrical equipment: Headlights and lighting VAZ-2115 (1997-2012)
➠ Electrical equipment: Headlights and lighting VAZ-2107 (1982-2012)

Share with friends: